Anchor-Roc™

Fast Turn Around Grouting

Anchor-Roc is a high performance multi-purpose grout, formulated as a quick curing, cost effective compound for fast turn around. application. Anchor-Roc can be applied in various consistencies, from fluid form to dry pack with early strength charateristics.

Anchor-Roc is a high-strength, cementitious, nonshrink, nonmetallic grout, designed for precision grouting applications. Anchor-Roc provides consistent performance in damp or wet environments, with maximum load bearing capacity, especially where nonshrink grout can be placed where fluid consistency is required.

Typical Application

Novafast is recommended for use where resistance to wetting and drying cycles occurs without expansive destruction.

Along with it's excellent properties, it can prevent potential damage to foundations of installed equipment. Anchor-Roc Grouting System is suitable for:

  • For sealing & supporting machine bases in factories
  • Crane rail bedding
  • Baseplates, structural columns
  • Pipes and sleeves, underpinnings
  • Highway barriers, fence posts, sole plates

Due to its quick cure times, Novafast presents an economical and practical alternative to carrying out repairs in factories and industrial
plants during maintenance shutdowns.

Specification

Set Times
Initial Final
Plastic Very Good 1.5 hours
Flowable 55% 2.8 hours
Fluid 500% 3.5 hours
Compreensive Strenght (ASTM C-109) MPa
1 day 3 days 7 days 28 days
Plastic 27 45 60 72
Flowable 20 39 59 69
Fluid 19 38 49 62
Expansion (CRD C-621)
In% 1 day 3 days 7 days 28 days
Plastic +0.03 +0.12 +0.13 +0.20
Flowable +0.03 +0.11 +0.14 +0.21
Fluid +0.04 +0.17 +0.18 +0.25
Anchor-Roc Application

Anchor-Roc Application

Preparation

Concrete substrate must be clean and free of any curing or sealing compounds,dust, dirt, oil or grease.

Base where possible, should be textured using a small chipping hammer.

Substrate must be presoaked with water for 24 hours to prevent premature drying of the grout.

Formwork is required for most grouting applications. Top edges of formwork must be higher than the bottom of the baseplate to be grouted.



PDF Data Sheet Download the Safety Data Sheet
Download the
product brochure
Download the
Safety Data Sheet
Follow our page on Follow our page on Linkedin
Quality Control

Quality Control

Beyond selecting elegible raw materials, Novafast products pass through high quality control and inspection...

Australian Brand

Australian Brand

Novafast is an Australian company and totally commited to providing the highest standard of composite products...

projects where Novafast is present